Resin anchors in Alford for carefully prepared fixings

Kemfix available. Solid and hollow substrates considered. Exact quantities supplied.

01

Bond anchoring components into drilled holes

Resin fixing systems bond threaded rod or reinforcing components into prepared holes, providing an anchoring method for suitable construction applications. We supply resin anchors in Alford, including resins and Kemfix products. Selection depends on the base material, intended load, hole diameter, embedment depth and installation conditions. Temperature and curing time also matter because the resin must be allowed to develop as specified before the anchor is loaded. Solid and hollow substrates can require different system components, so accurate substrate information is essential before choosing the product.

02

Preparation matters before the resin cures

A typical installation begins with drilling the correct hole, followed by thorough cleaning to remove dust and debris. Resin is then applied as directed, the component is inserted and the assembly remains undisturbed for the stated curing period. Skipping preparation can affect the bond, while loading too early can compromise the fixing. Tell us the substrate, rod size, hole diameter, embedment, load requirement and likely installation temperature. We can discuss a suitable product route and supply the quantities needed, without imposing a full-box requirement.

03

Plan each stage of the bonded anchor

Substrate considered

Distinguish solid and hollow materials before selecting the system.

Installation details

Check hole size, embedment, temperature and curing requirements.

Named resin range

Ask us about resins and Kemfix for suitable anchoring applications.

04 / FAQ

01

What information is needed to select a resin anchor?

Provide the base material, intended load, rod size, hole diameter, embedment depth and installation temperature. Tell us if the substrate is solid or hollow and include any stated project specification.

02

Why must the drilled hole be cleaned thoroughly?

Dust and loose debris can interfere with the resin's contact with the base material. Follow the system's drilling and cleaning procedure before injecting resin and inserting the anchoring component.

03

When can a chemical anchor be loaded?

Only after the applicable curing time has passed under the actual installation conditions. Temperature can affect this period, so follow the chosen product instructions rather than using a fixed assumption.

Find the fixings that suit your work

Call us with the substrate, load, hole size, embedment and installation conditions.

Contact Us